Fayat Group Dynapac CA25 Instruction Manual page 103

2
1
Fig. Engine:
1. Belt;
2. Tension pulley
Fig. Forward-reverse control
2. Screws
1
2
3
Fig. Engine compartment.
1. Air radiator
2. Oil radiator
3. Cooling radiator
02-17-2021
Diesel engine - Check the belt tension
Check the position of the belt in the tension pulley, it
should be centered, if the belt has too much wear replace
it.
Refer the engine manual for more information.
Controls – Lubrication
Lubricate the mechanical throttle forward-reverse system.
Remove the outer cover at the bottom of the seat by
loosening the screws (2). Lubricate the drive elements.
Refit the cover.
Radiator - Check/Cleaning
Check that air can pass unobstructed through the radiators
(1), (2) and (3).
Clean a dirty radiator using compressed air or a high-
pressure water jet.
Blow air or direct water through the cooler in the opposite
direction to that of the cooling air.
Be careful when using a high-pressure washer - do not
place the nozzle too close to the radiator.
Wear protective
compressed air or high-pressure water jets
4812325897EN
Maintenance – 2000 h
goggles when working with
103