Fayat Group Dynapac CA25 Instruction Manual page 102

Fig. Fuel tank:
1. Drainage plug.
2
Fig. Hydraulic oil reservoir, lower part:
1. Drain cock;
2. Plug.
02-17-2021
Fuel tank - Draining
Water and sediment in the fuel tank are removed via the
drainage plug (1) in the bottom of the fuel tank.
Be very careful during draining. Do not drop the plug or
else all the fuel will flow out.
Drain the roller after it has been stationary for a long time,
e.g. after standing overnight. The fuel level should be as
low as possible.
The roller should preferably have been standing with this
side somewhat lower, so that water and sediment will
gather near the drainage plug (1). Drain as follows:
- Place a container under the cock;
- Loosen the drain plug (1);
- Then open the drain plug and drain out water and
sediment until only pure diesel fuel emerges at the
plug.
- Screw the drainage plug again.
Hydraulic reservoir - Draining
The condensate from the hydraulic reservoir is drained
through the drain cock (1).
1
Drain the roller after it has been stationary for a long time,
e.g. after standing overnight. Drain as follows:
- Remove the plug (2);
- Place a container under the cock;
- Open the cock (1);
- Let any trapped condensate run out.;
- Shut the drainage tap. Refit the plug.
Hand in the drained oil to an environment-friendly
waste disposal station.
Take great care when draining warm fluid and
oil. Wear protective gloves and goggles.
4812325897EN
Maintenance – 2000 h
Store the waste and the oil and take them to a
waste disposal station with environmental rules.
102