Fayat Group Dynapac CA25 Instruction Manual page 10

02-17-2021
High pressure cleaning
Do not spray directly onto electrical components or control
panel.
Place a plastic bag over the reservoir lid and seal with a
rubber band. This prevents the water under pressure from
passing through the vent hole in the lid. This could cause
malfunctions, e.g. clogging of the filters.
When washing the machine, do not direct the water
jet directly into the tank cover. This is especially
important when using high-pressure jets.
Fire fighting
If the machine catches fire, use an BCD-class powder fire
extinguisher. A BC-class carbon dioxide fire extinguisher
can also be used.
Roll Over Protective Structure (ROPS), ROPS
approved cab
If the machine is fitted with a Roll Over Protective
Structure (ROPS, or ROPS approved cab) never
carry out any welding or drilling in the structure or
cab.
Never attempt to repair a damaged ROPS structure
or cab. These must be replaced with new ROPS
structure or cabs.
Welding
When carrying out welding on the machine, the
battery must be disconnected and the electronics
disconnected from the electrical system.
If possible, remove the part(s) to be welded from the
machine.
4812325897EN
Special instructions
10