Fayat Group Dynapac CA25 Instruction Manual page 44

2
5
Fig. Control panel:
2. Emergency shut-off;
5. Forward-Reverse lever;
12
Fig. Control panel
12. Parking brake
8. Speed selector.
02-17-2021
Starting the Diesel engine
Make sure the emergency stop button (2) is pulled.
Make sure the parking brake switch (12) is on.
The forward/reverse lever (5) shall be in the neutral
position. The Diesel engine cannot be started if the
lever is not in this position.
Set the speed selector (8) in the low idling position.
Pre-warm up: turn the key to position II. When the
display heating symbol goes out, set the start switch
to position 3c. As soon as the motor starts, release
the start switch.
Do not try to run the start engine for too long.
If it does not work, wait 60 seconds to try again.
At the start of the Diesel engine when the ambient
temperature is below +10 ° C (50 ° F), it must be
warmed up at idle (low speed) until the hydraulic oil
temperature exceeds +10 ° C (50 ° F).
8
With a temperature below 0°C (32°F), the Diesel
engine and hydraulic system must be heated for at
least 15 minutes.
When starting and driving a machine that is
cold, remember that the hydraulic fluid is also
cold and that braking distances can be longer
than normal until the machine reaches the
working temperature.
When the engine is running indoors, make sure
if there is proper ventilation to extract the
exhaust gases.
4812325897EN
Operation - Starting
44