Fayat Group Dynapac CA25 Instruction Manual page 92

Fig. Drum
1. Ventilation screw
Fig. Fuel tank:
1. Drainage plug.
02-17-2021
Drum cartridge - Cleaning the ventilation
Clean the drum's ventilation hole and ventilation screw
(1). The hole is required to eliminate excess pressure
inside the drum.
Fuel tank - Draining
Water and sediment in the fuel tank are removed via the
drainage plug (1) in the bottom of the fuel tank.
Be very careful during draining. Do not drop the plug or
else all the fuel will flow out.
Drain the roller after it has been stationary for a long time,
e.g. after standing overnight. The fuel level should be as
low as possible.
The roller should preferably have been standing with this
side somewhat lower, so that water and sediment will
gather near the drainage plug (1). Drain as follows:
- Place a container under the cock;
- Loosen the drain plug (1);
- Then open the drain plug and drain out water and
sediment until only pure diesel fuel emerges at the
plug.
- Screw the drainage plug again.
Store the waste and the oil and take them to a
waste disposal station with environmental rules.
4812325897EN
Maintenance – 1000 h
92