Fayat Group Dynapac CA25 Instruction Manual page 93

2
Fig. Hydraulic oil reservoir, lower part:
1. Drain cock;
2. Plug.
2
1
Fig. Engine:
1. Belt;
2. Tension pulley
Fig. Forward-reverse control
2. Screws
02-17-2021
Hydraulic reservoir - Draining
The condensate from the hydraulic reservoir is drained
through the drain cock (1).
1
Drain the roller after it has been stationary for a long time,
e.g. after standing overnight. Drain as follows:
- Remove the plug (2);
- Place a container under the cock;
- Open the cock (1);
- Let any trapped condensate run out.;
- Shut the drainage tap. Refit the plug.
Hand in the drained oil to an environment-friendly
waste disposal station.
Take great care when draining warm fluid and
oil. Wear protective gloves and goggles.
Diesel engine - Check the belt tension
Check the position of the belt in the tension pulley, it
should be centered, if the belt has too much wear
replace it.
Refer the engine manual for more information.
Controls – Lubrication
Lubricate the mechanical throttle forward-reverse system.
Remove the outer cover at the bottom of the seat by
loosening the screws (2). Lubricate the drive elements.
Refit the cover.
4812325897EN
Maintenance – 1000 h
93