Fayat Group Dynapac CA25 Instruction Manual page 84

Fig. Electrolyte level in the battery:
1. Cap;
2. Electrolyte level;
3. Plate.
Fig. Right side of the machine
1. Steering pump
2. Rear axle
3. Engine suspension
4. Wheel nuts
02-17-2021
Battery - Check condition
Remove the cap (1) and check that the electrolyte level (2)
is about 10 mm above the plates. If the level is low, fill up
with distilled water to the correct level.
If the ambient temperature is below freezing point, the
engine should be running for some time after adding the
distilled water. Otherwise there is a risk of the electrolyte
freezing.
Check that the ventilation holes in the element caps are
clogged and then place the cap.
The cable shoes should be clean and tightened. Corroded
cable shoes should be cleaned and greased with acid-
proof vaseline.
Be careful when washing with high pressure water and do
not place the jet nozzle too close to the radiator.
When disconnecting the battery, always disconnect the
negative cable first. When connecting the battery, always
connect the positive cable first.
Dispose of batteries properly. The battery
contains environmentally harmful lead.
When performing welding work on the machine,
disconnect the battery cable and then all the cables
connected to the alternator.
joints – Check
Bolted
Steering pump to Diesel engine (1), 55 N.m, lightly
lubricated.
Rear axle suspension (2), 330 N.m (243 ft/lbf), oiled.
Engine suspension (3). Check if all M12 bolts (20 pieces)
are tightened with 70 N.m and lightly greased.
Wheel nuts (4). Check if all nuts are tight, 630 N.mm, and
oiled.
(The above information is valid only for new or replaced
components).
4812325897EN
Maintenance – 500 h
84