Fayat Group Dynapac CA25 Instruction Manual page 71

Fig. Drum, left side
Fig. Cartridge, left side
1. Filler plug
2. Drain plug
3. Sight glass
Fig. Drum gearbox
1. Drain plug
2. Filler plug
3. Level plug
02-17-2021
Cartridge – Oil change
Park the machine on a flat surface so that the filler plug
(1) is perpendicular.
Place a container of approximately 5 liters capacity under
the drain plug (2).
Observe care when draining drum oil/hot drum oil.
Wear protective gloves and goggles
Save the oil and hand in to an environment-friendly
waste disposal station.
Clean and unscrew the filler plug (1) and the drain plug
(2).
Allow all the oil to run out. Fit the drain plug and fill with
new lubricant oil.
See lubricant specifications for more information about
quality.
Drum gearbox - Oil change
Place the machine on a flat surface so that the plugs (1)
and (2) are in the position shown in the figure.
Clean and remove the plugs (1) (2) (3) and drain the oil
into a container with a capacity of approximately 3,0 liters.
Replace the plug (1) and fill up with oil up to the level plug
(3) in accordance with the instructions under "Drum
gearbox - Oil level check".
Use transmission oil (see lubricant specifications).
Clean and refill the level plug (3) and filler plug (2).
4812325897EN
Maintenance, first 50 h
71