Ski Wear Bar; Recoil Starter Air Vents; Lights - Arctic Cat ZR 120 2021 Operator's Manual

Table of Contents

Advertisement

2. Adjust the ski alignment by rotating
the adjustment tie rod.
3. When steering alignment is correct,
apply blue Loctite #243 to the jam
nut threaded areas and tighten each
jam nut securely against its adjust-
ment tie rod.
! WARNING
Neglecting to lock the steering tie rod
by tightening the jam nuts against the
adjustment tie rod may cause loss of
snowmobile control and possible per-
sonal injury.

Ski Wear Bar

The ski wear bar is a replaceable bar
attached to the underside of the ski. The
purpose of the wear bar is to assist in
turning the snowmobile, to minimize ski
wear, and to maintain good steering con-
trol. If the snowmobile is operated pri-
marily in deep snow, ski wear bar wear
will be minimal; however, if the snow-
mobile is operated on terrain where the
snow cover is minimal, the ski wear bar
will wear faster.
To maintain positive steering characteris-
tics, Arctic Cat recommends that the ski
wear bars be checked once a week and
replaced if worn to 1/2 of original diame-
ter. Ski wear bars are available from an
authorized Arctic Cat Snowmobile dealer.
! WARNING
Operating
the
excessively worn ski wear bars may
result in a loss of steering control.
Removing Ski Wear Bar
1. Raise the front of the snowmobile.
2. Remove the lock nuts securing the
wear bar to the ski.
22
0735-446
snowmobile
with
3. Remove the wear bar.
Installing Ski Wear Bar
1. Insert the wear bar studs into the
holes in the ski.
2. Center the wear bar studs in the
holes and install the lock nuts.
3. Tighten lock nuts securely.

Recoil Starter Air Vents

It is important for proper engine cooling
that the air vents located on the recoil
starter are kept clean. These air vents
should be checked periodically and
cleaned if necessary.
CAUTION
Serious overheating of the engine
and engine damage will result if the
air vents are not kept clean.

Lights

The correct headlight bulb is p/n 0609-
991. The correct taillight is p/n 0609-934.
To change the headlight bulb, use the fol-
lowing procedure:
1. Open the hood; then disconnect the
harness connector from the head-
light bulb.
0750-990
0744-923

Advertisement

Table of Contents
loading

Table of Contents