Carry Out A Scrub Test - Proceq ZAA2600 Instruction Manual

ZAA2600 - Manual
Vibrations may occur during tests on rubber-like surfaces (e.g. soft-touch painting). In
such cases it is recommended to remove all rubber elements (foam cushion, hard rubber
cushion as well as the adhesive film).
Fig 7: Mounting for rubber-like surfaces

7.3 Carry out a scrub test

The side panels (17) must always be mounted during operation.
Never touch any moving parts during operation.
Depending on the abrasives used, the test may only be carried out in a ventilated
environment.
Place the device on a solid, even surface.

Level the apparatus using the included spirit level. To do so, place the spirit level on the

sample tray and adjust the levelling feet (9) until the ZAA 2600 is levelled perfectly. The
sample tray must be firmly in place.

Fold up the tool holder (4).

Open the screws of the sample frames (6) with a quarter-turn and remove the sample

frames (6).
Place the sample.

Replace the sample frames (6) in the unit and while pressing them down fasten the screws

with a quarter-turn.
Fold down the tool holder (4).

When testing flat samples mount the clips (8). They ensure stable running of the friction

sets.
23. September 2021 © Copyright 2021, PROCEQ SA 43