Position; Menu - Proceq ZAA2600 Instruction Manual

Automatic film applicator and testing system

Table of Contents

ZAA2600 - Manual

If the drawing area is defined through the manual stops (1 & 2), the drawing length

should be set to a high value, e.g. 400 mm. The drawing process will no longer be

defined by the set length and will automatically stop when it reaches one of the stops.

Film Testing: Setting the cycle speed

The double stroke speed can be set by tapping the Speed field. A slider will appear on the

right side of the touch screen to change the value. The value can also be changed by using

the

and

button.

The preset double stroke speed will automatically be saved in the currently selected layout.

Film Testing: Setting the stroke length

The stroke length can be set by tapping the Length field. A slider will appear on the right side

of the touch screen to change the value. The value can also be changed by using the

button.

The preset stroke length will automatically be saved in the currently selected layout.

10.1.7 Position

The position field shows the current position of the drawing unit (20) relative to the previously

defined zero position.

The menu can be opened using the „Menu"

from here.

As the ZAA2600 is an universal film application and test system, the unit perform film

application as well as various film testing, if equipped with the appropriate modification set.

E.g. crocking, scrubbing or scratching tests can also be made with the device. These

functions are always integrated in the menu, however they are not working without the

modification sets.

23. September 2021

button. Various settings can be changed

If you see this screen, the device is in film testing mode

(scrubbing/crocking). Go back to the application mode

as follows:

Open the menu

then tap „Applicator".

, select „Setup"and „Machine Mode",

and

Table of Contents