Table of Contents
Advertisement
ZAA2600 - Manual
Remount the side panels (15), the one with slit on the right side, the other one on the left
side.
Remount the start stop (1) and the end stop (2).
Move the start stop (1) backwards and the end stop (2) forward as far as possible. Fasten
the screws of the stops (1) and (2).
To protect persons and the apparatus, proper care must be taken when lifting or carrying
it. It is recommended to hold and carry the ZAA 2600 on both sides of the housing.
Always remove the glass plate before lifting or tilting the device.
5.2 Disassembly
In order to prevent damage during transport the ZAA2600 needs to be disassembled back to
the basic unit.
These steps are also required done before mounting another modification set.
5.2.1 Disassemly of ZA2600.A and ZAA2600.HA
Always switch off the device and unplug the power cable before dissembling.
To prevent transport damage, the weight (7) and the clamping (5) and holding devices (8)
must be disassembled as follows:
Remove the temperature controller (ZAA2600.HA only)
Loosen and remove the knurled screw (16) to remove the weight (7). First turn the weight
upwards by 90 ° and – in reversed order as at the assembly - first take one side of the
weight then the other out of the guides.
Remove the screw of the start stop (1) and end stop (2).
Remove the side panels (17), by loosening and removing the fixing screws (18).
23. September 2021
(4)
© Copyright 2021, PROCEQ SA
(5)
30
Advertisement
Table of Contents
