Table of Contents
Advertisement
ZAA2600 - Manual
Main screen for Film application:
Position indicator
Start Draw
Cycle-counter
10.1.1 Manual moving
The drawing unit (20) can be moved using the „Manual forward"
buttons.
If one of these buttons is pressed, the drawing unit (20) starts to move slowly.
If the button is pressed and held for more than a second, the speed will increase.
Alternatively the drawing unit (20) can also be moved by hand by applying forward or
backward pressure at the middle of the weight (7).
10.1.2 Zero the unit
Film application: Zero the drawing unit
The current position of the drawing unit (20) can be set to 0 by pressing the „Zero"
button.
Film testing: Zero the scrub tester
23. September 2021
Speed indicator
Length indicator
Pause
Lock
The current position of the tool holder (4) can be set to 0 by
pressing the „Zero" symbol
with „yes. Should this button be pressed accidentally during the
procedure, you can abort the zeroing process by pressing "no".
Note: Do not zero directly at the start stop (1), but at least ca. 3
mm in front.
© Copyright 2021, PROCEQ SA
Layout indicator
Manual Back
Manual Forward
Zero
Menu
and „Manual back"
Confirm the appearing message
60
Advertisement
Table of Contents
