Table of Contents
Advertisement
ZAA2600 - Manual
For lubrication proceed as follows:
Remove the inserted plate (see section 12).
Remove both side panels (17) with the Allen key.
Turn the apparatus carefully on one side so that the side opening of the cover becomes
accessible.
Put some drops of sewing machine oil on your finger and spread it over the whole length of
the guide rods.
Repeat this for the other side of the apparatus.
Adjust the start stop (1) at the very beginning and the end stop (2) at the very end and let
the apparatus run back and forth several times, so that the oil gets evenly distributed over
the whole length of the rods.
Remount the side panels (17), the one with slit on the right side, the other one on the left
side.
Place the plate again.
15.4 Replacing the fuse
If the apparatus cannot be switched on), this could be due to a defect fuse. You can replace
the fuse yourself by opening the fuse holder (14) on the back of the apparatus between the
main switch (15) and the power supply socket (13) carefully using a screw driver or a similar
tool.
Before replacing the fuse of the ZAA 2600, always switch off the apparatus and unplug
it.
Replace the fine fuse (14) only by an equivalent fuse of the same type with the
same specification.
Observe that the inscription at the connection caps of the fuse corresponds to one of
the following designations:
T 0.8 A / 250 V
T 800 mA / 250 V
T 800 / 250 V.
Clamp the new fuse into the fuse holder (14) and put it back in its place.
Should it still be impossible to switch on the apparatus, please contact Proceq SA or an
authorized Proceq Partner.
15.5 Inspection
The instrument should be checked for proper condition by a qualified electrician at an interval
of 2 years. Alternatively, this test may also be performed by Proceq SA or an authorized
Proceq Partner.
23. September 2021
© Copyright 2021, PROCEQ SA
76
Advertisement
Table of Contents
