Assembly And Starting Up; Initial Assembly; Assembly Of Zaa2600.A - Proceq ZAA2600 Instruction Manual

ZAA2600 - Manual

5 Assembly and starting up

5.1 Initial Assembly

Before the first use the apparatus has to be assembled or converted for use with the desired
options.

5.1.1 Assembly of ZAA2600.A

Loosen and remove the start stop (1) and the end stop (2).

Remove the side panel (17), by removing the fixing screws (18).

Mount the clamping device (5) and the holding device (8) with the four supplied Allen

screws.
(5)
Reassemble both side panels (17), the one with the slit on the right side, the other on the

left side.
Refasten the previously removed fixing screws of the start (1) and end stop (2).

Make sure that the four black rubber feet are mounted.

Open the clamping device (5), by pressing the release lever (4) and the clamping grip (3)

together, then tilt the clamping grip (3) backwards. The clamping device (5) can be moved
to the back at the same time.
Place the glass plate into the device with the required surface up. Use the printing blanket

when working with a wire-bar applicator or profile rod, the glass surface when working with
a gap applicator.
23. September 2021
(18)
(8)
© Copyright 2021, PROCEQ SA
(17)
23