Table of Contents
Advertisement
ZAA2600 - Manual
10.1.3 Start
Film application: start the draw
The application procedure is started by pressing the „Draw" button.
Depending on the drawing mode selected, the draw button shows a straight arrow
for
"Single" mode or a curved arrow
for "Reverse" mode.
Film testing: start the scrubbing/crocking
The scrubbing/crocking procedure starts when pressing the „Scrubbing" button
.
The meter counts the double strokes made. The scrubbing procedure stops automatically
when the set number of double strokes has been reached.
One double stroke equates to one forward and backward movement of the tool holder (4).
10.1.4 Pause
The application process can be interrupted by pressing the „Pause"
button.
The drawing process continuous when the „Draw" button is pressed again.
10.1.5 Select Layout
The layout indicator shows the name of the currently selected layout. A layout is a
renameable memory slot storing a drawing speed and a drawing length. This is especially
useful for recurring tasks where the same speed and length are required.
The current layout can be selected by tapping the layout field.
10.1.6 Settings
Film application: Setting the drawing speed
The drawing speed can be set by tapping the Speed field. A slider will appear on the right
side of the screen to change the value. The value can also be changed by using the
and
buttons.
The adjusted value of the drawing speed will automatically be saved in the currently selected
layout.
Film application: Setting the drawing length
The drawing length can be set by tapping the Length field. A slider will appear on the right
side of the touch screen to change the value. The value can also be changed by using the
and
button.
The adjusted value of the drawing length will automatically be saved in the currently selected
layout.
23. September 2021
© Copyright 2021, PROCEQ SA
61
Advertisement
Table of Contents
