Table of Contents
Advertisement
ZAA2600 - Manual
10.4.1 Return speed
Return speed sets the speed at which the holding device (8) returns automatically to the zero
position after application when in „Reverse"
mode)
10.4.2 Manual speed
Manual drive speed sets the speed at which the drawing unit (20) moves when using the
„manual back"
or "manual forward"
10.4.3 Speed mode
There are two speed modes:
Normal 0 – 300 mm/s:
Fast 0 – 600 mm/s:
If not specifically required otherwise, it is recommended to use the „Normal" speed mode for
most applications.
10.4.4 Acceleration mode
There are three different acceleration modes:
Normal
The normal mode is appropriate for most uses.
Increased
The increased acceleration is for uses where the top drawing speed needs
to be reached quickly.
High
The high acceleration mode is only appropriate for uses with very high
speed, requiring the top drawing speed to be reached as fast as possible.
High acceleration mode can lead to a jerk at the start of the drawing
process.
If it is not specifically required otherwise, it is recommended to use the „Normal" acceleration
mode for most applications.
10.4.5 Reset cycle counter
23. September 2021
mode. (only applicable in Film Application
buttons.
The normal speed mode is appropriate for most uses.
The fast mode is for applications requiring high drawing speed.
With the „Reset" button the cycle counter (double stroke
counter) will be reset. This cannot be undone.
If the „Reset" button has been tapped this message
appears which has to be either confirmed or rejected.
Only in Film Testing (Scrub/Crock) Mode.
© Copyright 2021, PROCEQ SA
67
Advertisement
Table of Contents
