Table of Contents
Advertisement
ZAA2600 - Manual
12 Removing the heating plate of a ZAA2600.HA
If the glass plate is needed for application, the heating plate has to be removed. Change the
plate as follows:
Make sure that the adjustable start stop (1) and the drawing unit (23) are positioned in the
very back of the device and that the clamping device (5) is released.
Lift the weight (7) and hinge it into the top position (6) of the holding device (8).
Carefully lift the heating plate at the front edge and pull it out of the apparatus.
Carefully place the glass plate into the holder with the required side facing up. Use the
printing blanket when working with a wire-bar applicator or profile rod, the glass surface
when working with a gap applicator.
23. September 2021
© Copyright 2021, PROCEQ SA
72
Advertisement
Table of Contents
