Table of Contents
Advertisement
ZAA2600 - Manual
Position the end stop (2) behind the desired drawing area and lock it with the screw. (The
end stop (2) has a safety function.)
The end of the drawing area is defined by the two side parts of the collecting device as
shown on the picture below.
Set the drawing length using the touchscreen. Set the drawing length to the maximum on
the touch screen to ensure the collecting device to lift the applicator rod properly.
Lower the weight (7) until it sits on the applicator rod and holds it in place.
Hint: Place a piece of paper at the end of the substrate to absorb any excess coating
material.
Set the desired drawing speed on the touch screen (see chapter 10.1.6 "Settings
Film application: Setting the drawing speed" on page 61).
Apply the desired quantity of coating material on the substrate in front of the applicator rod.
Start the application procedure by tapping the arrow button
6.2.2 ACC1348 Fixing unit for profile rods and wire-bar applicators
Place the profile rod or wire-bar applicator into the holding device (8).
Fix the optional ACC1348 fixing unit on the sides of the applicator rod as shown below:
6.3 Application with gap applicator
Make sure that the glass plate is mounted with its glass surface facing up. Alternatively a
precision-vacuumplate can be used.
Set the start stop (1) as follows:
Place your substrate (e.g. test chart / film) at the desired position on the glass plate and fix
it with the clamping device (5), by pulling on the clamping grip (3). Keep in mind that the
gap applicator will be placed in front of the weight (7).
Hint: If the substrate is too small to use the clamping device (5), use a piece of adhesive
tape or an optional precision-vacuumplate to fix it.
23. September 2021
© Copyright 2021, PROCEQ SA
on the touch screen
37
Advertisement
Table of Contents
