Table of Contents
Advertisement
ZAA2600 - Manual
6 Film Application
6.1 Preparation
Before the apparatus is prepared for application, you should have decided:
which type of applicator you will be using
which substrate you will be using
which base plate you will be using
If using a wire-bar or profile rod, use the printing blanket side of the glass plate. For other
applicators, use the glass plate with the glass surface up.
Depending on the coating material used, the test may only be carried out in a ventilated
environment.
Heating of substances can lead to risk of explosion, implosion or the release of toxic or
flammable gases. If heating of a product can lead to the release of hazardous
substances, it is necessary to use an appropriate extraction system.
During operation, the distance to walls and to other objects must be at least 10 cm.
6.2 Application with wire-bar or profile rod
Place the device on a solid, even surface.
Level the apparatus using the included spirit level. To do so, place the spirit level on the
glass plate and adjust the levelling feet (9) until the ZAA 2600 is levelled perfectly. The glass
plate must be firmly in place.
Make sure that the printing blanket side of the glass plate is facing up.
Ensure that the printing blanket is covered with the polyester mat.
Set the „Moving Mode" to „Single", by tapping on „Menu" and „Setup" on the touchscreen.
"Single" mode is indicated with a straight arrow
•
Lift up the weight (7) and hinge it into the top position.
Set the start stop (1) as follows:
Move the open clamping device (5) and the holding device (8) to the back of the apparatus.
Place your substrate (e.g. test chart / film) at the desired position on the glass plate and fix
it with the clamping device (5), by pulling on the clamping grip (3).
Move the holding device (8) to the start stop (1) or to the desired starting position using the
button on the touchscreen.
Press the „Zero" button
23. September 2021
glass plate
precision vacuum plate
heatable precision vacuum plate (only versions with special isolation
plate)
heating plate (only versions with special isolation plate) or
on the touchscreen to set the start position.
© Copyright 2021, PROCEQ SA
on the main screen.
34
Advertisement
Table of Contents
