Compactflash® Setup; Lvds Voltage Selection; Figure 4-5: Compactflash® Setup Jumper Location; Table 4-4: Compactflash® Setup Jumper Settings - IEI Technology PM-PV-N4551/D5251 User Manual

4.6.3 CompactFlash® Setup
Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
The CompactFlash® slot is connected through an IDE connection. This switch sets the
CompactFlash® card as the master or slave IDE device.
Setting
Default position
(marked on board)
Other position
Table 4-4: CompactFlash® Setup Jumper Settings
Figure 4-5: CompactFlash® Setup Jumper Location

4.6.4 LVDS Voltage Selection

WARNING:
Incorrect voltages can destroy the LCD panel. Make sure to select a
voltage that matches the voltage required by the LCD panel.
Page 44
PM-PV-N4551/D5251 User Manual
SW_CF1
switch
See Table 4-4
See Figure 4-5
Description
Slave
Master