Lvds Voltage Selection; Table 4-2: Lvds Voltage Selection Jumper Settings - IEI Technology HYPER-AL series User Manual

4.5.1 LVDS Voltage Selection

WARNING:
Incorrect voltages can destroy the LCD panel. Make sure to select a
voltage that matches the voltage required by the LCD panel.
Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
The LCD voltage selection jumper sets the voltage of the power supplied of the LCD
panel.
Setting
Short 1-3
Short 2-4
Short 3-5
Short 4-6

Table 4-2: LVDS Voltage Selection Jumper Settings

Figure 4-5: LVDS Voltage Selection Jumper Location
Page 42
J_VLVDS1
6-pin header, p=2.00 mm
See Table 4-2
See Figure 4-5
Description
Backlight Enable +3.3 V
Set the voltage level of panel to +3.3 V
Backlight Enable +5 V
Set the voltage level of panel to +5 V
HYPER-AL SBC