Appendix A1 Pump Display Terminal; A1.1 Leds; A1.2 Pump Start / Stop And Control - Edwards iXL600 Instruction Manual

Appendix A1
The PDT accessory provides pump on/off and status reporting. Warnings and alarms are also indicated to the user.
Up to two PDTs may be fitted to the pump.
A1.1 LEDs
Local Control Green illuminates continuously when this PDT has control of the pump.
Pump ON Green (within the Pump Start button) illuminates to indicate that the pump is running.
Warning Yellow illuminates to indicate that a pump warning is present. It flashes when a new warning
occurs until it is acknowledged by pressing 'ENTER' when it goes continuous until the warning clears.
Alarm Red illuminates to indicate that a pump alarm is present. It flashes when a new alarm occurs
until it is acknowledged by pressing 'ENTER' when it goes continuous until the alarm clears.
A1.2 Pump start / stop and control
To Start or Stop the pump the PDT must be in control, indicated by the Local Control LED being illuminated.
To take or release control briefly press Control.
If something else is in control, error message 'Control locked' appears, refer to 'Control Holder' in the Status menu.
Press Start button PDT displays:
Pump State Local Control LED
Stopped On
Running On
Stopped or Running Off
© Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Pump display terminal
Figure A1 - Pump display terminal
Table A1 - Pump start control
PDT display
START MENU Start
Pump
Pump Running Press
CANCEL
No PDT Control Press
CANCEL
Operator Pump response
Press ENTER to con- Pump Starts
firm
Press CANCEL No change (running)
Press CANCEL No change
A540-55-880 Issue D
Page 49