Edwards iXL600 Instruction Manual page 19

Description
Short circuit current rating
(when installed with class T or
class J fuses)
Second protective earth (ground)
conductor
*
Typical earth leakage
for 200 - 230 V supply
for 380 - 460 V supply
*
Typical earth leakage values were measured at steady-state conditions.
Note that higher leakage currents may occur:
i) under transient conditions such as power on or pump acceleration or
ii) with abnormal supply configurations such as a missing or earthed phase or unbalanced supply voltages.
Contact Edwards for more information about configuration requirements for earth leakage reduction.
Description
Mains connection
Refer to installation section for
wiring diagram
PDT Interface (front)
System/PDT Interface (rear)
Ethernet interface
EMS interface
External emergency stop switch
Pin 1 - supply, Pin 2 - return
Note: If there is no external
connection a link plug must be fitted
to operate the pump.
Comms 24 V supply
Pin 5 - supply, Pin 6 - 0 V supply
common
© Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Table 7 - General electrical data (continued)
Rating
200
Must be fitted with cross-sectional area at least equal to phase
conductor size of 6 mm
<5
<10
Table 8 - Electrical connections
Mating Connector description /
external supply rating
Weidmuller Axial screw connector:
Insert type HDC S4 BAS
p/n:1789980000
Hood type HDC 16D TOLU 1PG21G
p/n:1652680000
Alternative: Harting Axial screw
connector
Insert type Han 40A Axial module
p/n:09140022701 x 2 off used with
p/n:09140060313 (Hinged Frame)
Hood type PG21 Top Entry
p/n:09300060442
2
6 mm stranded wire, 13-18 mm
cable OD
XLR type 5-way plug
XLR type 5-way plug
Standard RJ45 type or Neutrik
®
EtherCon
XLR type 6-way plug
2
Internal supply rating
®
RJ45
A540-55-880 Issue D
Units
kA
mA
mA
24 V d.c. 0.2 A
*
24 V d.c. 0.75 A
(IEEE802.3i
10 Base T Ethernet)
24 V d.c. 100 mA
*
24 V d.c. 0.75 A
Page 11