A1.4.2 Status Menu; A1.4.3 Setup Menu; Status Menu; Setup Menu - Edwards iXL600 Instruction Manual

By default the 4 parameters displayed in the Normal menu are as shown above but these may be changed via the Edit
Display attributes menu, accessed from the SETUP menu.
A1.4.2

Status menu

Press the Status button to enter. Scroll by pressing up/down keys. Press CANCEL to exit back to Normal menu.
If a device is not fitted the associated parameters will not be displayed. Parameters displayed:
Description
Serial Number
Control Holder
Dry Pump current
Booster current
Green Mode state
Dry Pump temperature
Booster Temperature
Booster MB End Cover temperature
N Flow Rate
2
Dry Pump Power
Booster Power
Dry Pump speed in percent
Dry Pump speed in Hz
Booster speed in percent
Booster speed in Hz
Dry Pump Inverter Temperature
Booster Inverter Temperature
Run Hours
Number of Pump Starts
Time to Stop (seconds)
Active Alarms and Warnings (if present)
A1.4.3

SETUP menu

Press the Setup button to enter. Menu title is shown at the top of the display. Scroll by pressing up/down keys. Press
ENTER to open a sub menu or CANCEL to exit back to Normal menu.
Description
*
Commands menu
Display Inverter Fault History menu
Software Version Display menu
Display Serial Number
*
Fit Accessory menu
Edit IP configuration menu
© Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Table A4 - Status menu
Typical Display
S/N 1234567
NONE IN CONTROL
DP CURRENT
MB CURRENT
Green Mode STATE
DP TEMP
MB TEMP
MB E/C TEMP
N FLOW
2
DP POWER
MB POWER
DP SPEED
DP SPEED
MB SPEED
MB SPEED
DP INV TEMP
MB INV TEMP
RUN HOURS
PUMP STARTS
TIME TO STOP
Table A5 - SETUP menu
Display
Command Menu...
Inv Fault Hist...
S/W Version...
Serial Num...
Fit Accessory...
IP Config...
A540-55-880 Issue D
1.1A
1.1A
Off
100C
100C
100C
44 slm
1.1 kW
1.1 kW
100 %
100 Hz
100 %
100 Hz
100C
100C
1000
100
900
Page 51