Chapter 15 - Installing And Connecting Sdi And Ethernet Ports - Nortel Meridian 1 Planning And Installation Manual

Chapter 15 — Installing and connecting
SDI and ethernet ports
This chapter contains modem setup requirements and the following two
procedures for connecting communication devices to the Option 11C Mini:
• Procedure 57 "Connecting SDI ports on the MSC card" on page 253
explains how to install and connect SDI ports to terminals and modems.
This procedure provides instructions on how to access ports through the
NTDK97, NTAK02, and NTAK03 cards.
• Procedure 58 "Setting up the terminal" on page 261 provides procedures
for setting up the terminal.
• Procedure 59 "Connecting the Ethernet cable" on page 267 describes
how to install and connect the Ethernet cable.
In an Option 11C Mini system, the following cards provide SDI ports:
• NTDK97 MSC card provides three SDI ports
• NTAK02 SDI/DCH card provides four ports of which up to two can be
SDI ports
• NTAK03 TDS/DTR card provides two SDI ports
Note: The NTDK97 MSC card includes the functionality of the
NTAK03 card. However, you can also configure the NTAK03 card, if
required.
Option 11C Mini Planning and Installation Guide
Page 251 of 590