Activating A Selected Model Trunk - Nortel Meridian 1 Planning And Installation Manual
Hide thumbs
Also See for Meridian 1:
- Manual (1121 pages) ,
- Planning, installation and operating instructions (556 pages) ,
- Administration and maintenance (507 pages)
Table of Contents
Advertisement
Activating a selected model trunk
Due to the automatic 30 second time-out on the administration menu, prepare
the data that you want to input before you begin. To determine the
corresponding TNs and trunks, check the location of trunk cards in the chassis
or use LD 32.
Procedure 75
Activating a selected model trunk
1
Lift the handset of the administration telephone.
2
Enter the administration Flexible Feature Code to access the
administration menu.
3
Enter the default administration telephone password.
You hear special dial tone and the prompt "TASK?" appears on the top
line of the character display. The second line of the character display
reads "1 ADD TRUNK".
4
Select "1 ADD TRUNK" by entering the number "1".
The prompt
"ROUTE ACCESS?" appears.
5
Enter the access code of the configured trunk route to which you
want to add the trunk and press the pound key (#).
The prompt
"TN?" asks you to enter a TN from one of the installed trunk cards. If
you do not enter a valid route number, "TN?" does not appear and the
screen remains the same. If the card does not match the route, the
prompt "ROUTE ACCESS?" appears again, and you hear overflow
tone.
6
Enter the TN in Option 11 format (CCUU).
The response
"MODEL?"
prompts you to select a model number for the trunk.
Chapter 18 — Connecting the trunks
Option 11C Mini
Page 339 of 590
Planning and Installation Guide
Advertisement
Table of Contents
