Nortel Meridian 1 Planning And Installation Manual page 262

Chapter 13 — Installing and connecting the cross-connect terminal
Figure 55
A ferrite filter installed on a 25-pair cable (EMC system)
25-pair cable
to cross-connect
terminal
Velcro strap
Ferrite filter
5 Terminate all the 25-pair cables installed at the cross-connect
terminal.
Label all the cables at the cross-connect terminal blocks according to
the card slot assignment plan.
6 Install the AUX cable on the lower 9-pin connector located on the
bottom left-hand side of the Main Chassis. See Figure 56.
Option 11C Mini Planning and Installation Guide
Page 241 of 590
553-9030