Ntag04Aa Central Office/Direct Inward Dial Trunk Card - Nortel Meridian 1 Planning And Installation Manual

NTAG04AA Central Office/Direct Inward Dial trunk card

Switch settings
The NTAG04AA card does not have any option switches. Configure all
settings in software.
Procedure 43
Installation of the NTAG04AA Central Office/Direct Inward Dial trunk
card
1 Insert the card into the selected card slot and lock it in position.
2 Connect the trunk units to the cross-connect terminal by tip and
ring leads (Refer to "Chapter 18 — Connecting the trunks" on
page 313).
3 Configure the card in software (LDs 16 and 14).
—————————— End of Procedure ——————————
LD 16 - Route Data Block
Prompt
REQ
TYPE
CUST
ROUT
TKTP
ICOG
ACOD
CNTL
TIMER
DTD
2DT
SCDT
Chapter 12 — Installing the circuit cards
Response Comments
NEW
RDB Define a new Route Data Block
0-99 Enter customer number
0-511 Enter route number
COT Define the trunk type as central office
IAO Incoming and Outgoing trunk
XXXXXXX Trunk route access code
YES Change a trunk timer
DSI 2048 Disconnect Supervision Timer =
2048 ms
GTI 512 Incoming Guard Timer = 512 ms
GTO 512 Outgoing Guard Timer = 512 ms
RGV 256 Ring Validation Timer = 256 ms
YES Dial tone detector performed on this
route
YES
NO Secondary dial tone is not used in
Holland
Option 11C Mini
Page 203 of 590
Planning and Installation Guide