Nortel Meridian 1 Planning And Installation Manual page 179

Chapter 12 — Installing the circuit cards
LD 16 - Route Data Block
Prompt Response
REQ NEW
TYPE RDB
CUST 0-99
ROUT 0-511
TKTP TIE, RAN, PAG
ICOG IAO
ACOD XX
Trunk Data Block
Use Overlay 14 to configure each of the trunk units on the NT5K83DB card.
In the Overlay tables, default values are in parenthesis.
LD 14 - Trunk Data Block
Prompt Response
REQ NEW
TYPE TIE, RAN, PAG
TN CC UU
XTRK XFEM
(see note)
SIGL EM4, EAM, WR4 4 wire E&M, 2-wire E&M,
EMTY TY1, (TY2)
STRI IMM, WNK, DDL,
SACK, PTSD
STRO IMM, WNK, DDL,
SACK, PTSD
Comments
Define a new Route Data Block
Enter customer number
Enter route number
Define the trunk type as TIE,
Recorded announcement or Paging
Incoming and Outgoing trunk
XX=Trunk route access code
Comments
Define a new trunk unit
Trunk type TIE, (Recorded
announcement), (Voice paging)
Terminal number of the unit:
Card, Unit
Type is IPE XFEM
CEPT L1 signaling
Type 1 signaling, (Type 2)
Incoming start Immediate, Wink,
Delayed dial, Seize Ack, Proceed to
send
Outgoing start immediate, Wink,
Delayed Dial, Seize ACK, Proceed to
Send
Option 11C Mini Planning and Installation Guide
Page 159 of 590