Nortel Meridian 1 Planning And Installation Manual page 232

Page 212 of 590
553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
LD 16 - Route Data Block
Prompt Response
NEDC ETH
FEDC ETH
CDR YES, (NO)
OAL YES, (NO)
MR PPM
Trunk Data Block
Use Overlay 14 to configure each of the trunk units on the NTCK24AA
Central Office trunk.
LD 14 - Route Data Block
Prompt Response
REQ NEW
TYPE COT
TN CC UU
CDEN (8D)
XTRK XCOT
(see note)
SIGL LOP
PPID 07
BTID 07
CLS DTN, (DIP)
Note: These prompts are required only for the first unit defined on each
NTCK24AA card.
July 1999
Comments
Near end disconnect control from
either end
Far end disconnect control from either
end
CDR trunk route. If Yes, answer OAL
and MR prompts.
CDR on outgoing calls
Buffered PPM signals counted on this
route
Comments
Define a new trunk unit
Central Office Trunk
Terminal number of the unit:
CC=card number
UU=unit number
Card density is 8D (default)
Type is IPE COT
Loop Start signaling
PPM country Identification
Busy Tone country identification
Digitone signaling, (Digipulse)