Equipment Layout Plan For Installing The Chassis On A Table - Nortel Meridian 1 Planning And Installation Manual

Chapter 4 — Creating an equipment layout plan and a card slot assignment plan

Equipment layout plan for installing the chassis on a table

To install an Option 11C Mini on a table, the available table-top space must
be large enough to hold the Main Chassis and Chassis Expander. See
Figure 10.
Note 1: If you are installing only a Main Chassis now, leave enough
space for additional chassis to avoid problems in the future.
Note 2: You can place the Main Chassis directly on top of the Chassis
Expander.
Wall space must be available for the cross-connect terminal, the
cross-connect cables, and any miscellaneous equipment (such as a power
supply for digit displays on telephones).
Leave at least 12 in. (305 mm) of space between the top of the chassis
and any obstruction (such as a shelf) to permit enough air circulation.
Do not place the chassis on the floor, as dust can enter the system. This
results in damage to the system.
CAUTION
Option 11C Mini Planning and Installation Guide
Page 55 of 590