Installing The Chassis On A Wall In A Horizontal Position; Items Required - Nortel Meridian 1 Planning And Installation Manual

Installing the chassis on a wall in a horizontal position

Items required

To install the chassis on a wall in a horizontal position, you require the
following items:
•
•
•
•
•
The NTTK11 bracket kit contains all of the above items, with the exception
of the equipment layout plan and the plywood.
Refer to Figure 25 on page 100 for guidelines on how to position system
components.
Chapter 9 — Installing the chassis
equipment layout plan
one left shelf bracket
one right shelf bracket
eight 1 in. #12 wood screws supplied in the bracket kit (or other
appropriate fasteners) to fasten the wall shelf brackets to the wall
one 3/4 in. (20 mm.) piece of plywood fastened to the wall
An Option 11C Mini chassis with circuit cards installed weighs 30 lb.
(13.5 kg). Make sure that you fasten the equipment securely to the
wall. Use fasteners that are designed to hold securely the type of
surface selected to support the equipment. When using 3/4 in. (20 mm)
plywood or other similar material as a backboard, make sure you
attach it directly to the wall studs in a minimum of six places.
CAUTION
Option 11C Mini Planning and Installation Guide
Page 99 of 590