Nt8D14 Universal Trunk Card - Nortel Meridian 1 Planning And Installation Manual

Page 136 of 590

NT8D14 Universal Trunk card

553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
The NT8D14 Universal Trunk card provides eight analog trunks which can
function in the modes shown in Table 19.
You can install this line card in slots 1 through 3 in the Main Chassis or slots
7 through 10 in the Chassis Expander.
Procedure 11
Universal Trunk card installation
1 Set the jumpers for the NT8D14 Universal Trunk circuit card
according to
Table 19
NT8D14 Universal trunk — modes and option settings
Modes
Central (CO)
2-way TIE trunk (loop Dial Repeat)
2-way TIE trunk (Outgoing Incoming
Dial)
Recorded Announcement (RAN)
Paging trunk
Japan CO/DID operation
DID operation
Loop length>2000 ¾
DID operation
Loop length <2000¾
Note: OFF indicates no strap present.
J1 and J2 locations apply to all eight trunks.
2 Insert the card in its assigned slot.
—————————— End of Procedure ——————————
July 1999
Table 19 .
Jumper
Location
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
J1, J2
strap
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF