Nortel Meridian 1 Planning And Installation Manual page 240

Page 220 of 590
553-3021-209 Standard 1.00
Chapter 12 — Installing the circuit cards
Trunk Data Block
Use Overlay 14 to configure each of the trunk units on the NTCK22AA card.
The Overlay table below shows the DID trunk data block layout.
LD 14 - Trunk Data Block
Prompt Response
REQ NEW
TYPE DID
TN CC UU
XTRK XDID
(see note)
SIGL EAM
BIMP 600/3COM
STRI IMM
STRO IMM
SUPN YES
CLS SHL, (LOL)
DTN, (DIP)
Note: These prompts are required only for the first unit defined on each
NTCK22AA card.
July 1999
Comments
Define a new trunk unit
Direct Inward Dial
Terminal Number of the unit:
Card, Unit
Type is IPE DID
E&M signaling
Terminal Balance Selection
Immediate
Answer and disconnect supervision
required
Attenuation pads in, (out)
Digitone dialing, (Digipulse)