Reel Assembly - Toro Reelmaster 3100-D Service Manual

Reel Assembly

g343551
1. Bedbar assembly
2. Cutting unit frame
3. Flange bushing (2 each)
4. Plastic washer (4 each)
5. Metal washer (2 each)
6. Bedbar pivot bolt (2 each)
Reelmaster ® 3100-D/3105-D
20252SL Rev A
7. Lock nut (2 each)
8. RH side plate
9. LH side plate
10. Weight
11. Cap screw (2 each)
12. O-ring
Note: This section provides the procedure for removing and installing the cutting
reel assembly (cutting reel, spline inserts, grease seals and bearings) from the
cutting unit.
Note: Refer to Reel Assembly Service (page 8–26)
cutting reel seals and bearings.
Figure 177
13.
14.
15.
16.
17.
18.
Page 8–19
Cutting reel assembly
Wire spring
Flange nut (3 each per side plate)
Shoulder bolt (3 each per side plate)
Cap screw (2 each)
O-ring
for information on replacing
DPA Cutting Units: Service and Repairs