Toro Reelmaster 3100-D Service Manual page 299

Disassembling the Steering Column
Assembling the Steering Column
Reelmaster ® 3100-D/3105-D
20252SL Rev A
1. Park machine on a level surface, lower cutting units, stop engine, engage
parking brake, and remove key from the key switch.
2. Remove the philips pan head screws and steering wheel cap from the
steering wheel.
3. Remove steering wheel nut from the steering control valve. Pull steering
wheel from the control valve.
4. Remove steering cover from the steering control valve bracket.
5. Remove four bolts that securing the steering control valve to the steering
control valve bracket.
g345940
1. Tilt bracket
2. Jam nut
3. Flat washer
6. Remove both hex flange nuts, bolts, and pivot hubs securing the steering
control valve bracket to the steering arm. Slide bracket from the steering
control valve and steering arm.
7. Remove and replace parts as necessary to repair steering column using
Figure 158 and Figure 159
1. Make sure lever and friction discs are properly assembled to the steering
control valve bracket using
2. Position steering control bracket to the steering control valve and steering
arm. Secure bracket to the steering arm with pivot hubs, bolts, and hex
flange nuts.
3. Secure steering control valve bracket to the steering control valve with four
bolts.
4. Secure steering cover to the steering control valve bracket with cap screws.
Figure 159
4. Friction disc
5. Steering tilt lever
as a guide.
Figure 158 and
Page 7–21 Wheels, Brakes and Chassis: Service and Repairs
Figure 159 as a guide.