Gear Box Assembly
g343768
1.
Gear box assembly
2.
Rear roller brush drive shield
Removing the Gear Box Assembly
Reelmaster
®
3100-D/3105-D
20252SL Rev A
3.
Cotter pin
4.
Clevis pin
Note: The groomer gear box assembly is located on the opposite side of the
cutting unit from the cutting unit hydraulic motor.
1. Park machine on a clean and level surface, lower cutting units completely
to the ground, stop engine, engage parking brake and remove key from the
key switch.
2. Remove the groomer reel assembly (refer to
Note: If cutting unit is equipped with an optional powered rear roller brush,
remove the rear roller brush cover, drive belt and drive housing assembly to
service the groomer drive (refer to
(page 8–34)
for additional information).
Contact with the reel or other cutting unit parts can result in personal
injury. Use heavy gloves when handling the cutting reel.
Figure 205
Removing the Rear Roller (Figure 188)
CAUTION
Page 9–5
Universal Groomer (Optional): Service and Repairs
5.
Input shaft
Groomer Reel (page
9–15)).