Toro Reelmaster 3100-D Service Manual page 331

Installing the Reel Assembly (continued)
Reelmaster ® 3100-D/3105-D
20252SL Rev A
g343554
1. Side plate - RH
4. Apply a thin coat of antiseize lubricant to the reel bearing bore of each side
plate (Figure 180).
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when installing the cutting reel.
5. Make sure that the flat wire spring (item 14 in
LH side plate.
6. Carefully slide the RH end of the cutting reel assembly (no groove in reel
shaft or on face of threaded insert) into the RH side plate. Make sure that
bearing is fully seated into side plate.
7. Slide the LH side plate onto the cutting reel assembly.
8. Install shoulder bolts and flange nuts that secure the LH side plate to the
cutting unit frame. Torque the shoulder bolts from 37 to 44 N·m (27 to 33
ft-lbs).
9. Apply Loctite #243 (or equivalent) to threads of flange head screw that
secures support rod to LH side plate. Install screw and torque from 37 to 44
N·m (27 to 33 ft-lbs).
10. Install cap screw and flat washer that secure rear grass shield to LH side
plate. Torque screw from 20 to 25 N·m (15 to 19 ft-lbs).
11. Install the bedbar assembly (refer to
8–11)).
12. Install front and rear rollers (refer to
and Installing the Rear Roller (Figure 188) (page
Figure 180
2. Side plate - LH
CAUTION
Installing the Bedbar Assembly (page
Installing the Front Roller (page 8–31)
Page 8–23
Figure 177) is installed into
8–34)).
DPA Cutting Units: Service and Repairs