Servicing The Bedbar Adjuster - Toro Reelmaster 3100-D Service Manual

Servicing the Bedbar Adjuster

g343496
1. Bedbar assembly
2. Compression spring
3. Lock nut
4. Bedbar adjuster screw
Removing the Bedbar Adjuster
Installing the Bedbar Adjuster
Reelmaster ® 3100-D/3105-D
20252SL Rev A
5. Flange bushing
6. Cap screw
7. Detent
8. Lock nut
1. Remove the lock nut (item 3 in
from bedbar adjuster screw (item 4).
2. Remove the bedbar assembly (refer to
(page 8–10)).
3. Remove the bedbar adjuster screw (left hand threads) from the bedbar
adjuster shaft (item 10).
4. Remove lock nut and flat washer from adjuster shaft. Slide adjuster shaft
and wave washer from cutting unit frame.
5. Inspect the flange bushings (item 5) in cutting unit frame and remove if
necessary.
6. If detent is damaged, remove it from cutting unit side plate by removing the
cap screw.
1. If the detent (item 7
equivalent) to threads of cap screw and secure detent to cutting unit side
plate with cap screw. Tighten cap screw from 19 to 21 N·m (14 to 16 ft-lb).
2. If the flange bushings (item 5) were removed, apply antiseize lubricant to
bore of cutting unit frame. Align key on bushing to slot in frame and install
bushings into frame. Apply antiseize lubricant to bore of each flange bushing.
3. Slide wave washer onto adjuster shaft and then slide adjuster shaft into
flange bushings in cutting unit frame. Secure adjuster shaft with flat washer
Figure 176
10.
11.
12.
Figure 176), compression spring and washer
Removing the Bedbar Assembly
Figure 176) was removed, apply Loctite #243 (or
Page 8–17
9. Flat washer
Bedbar adjuster shaft
Washer
Wave washer
DPA Cutting Units: Service and Repairs