Mow/Transport Switch - Toro Reelmaster 3100-D Service Manual

Mow/Transport Switch

Testing
Electrical System: Component Testing
g346739
1. Mow/Transport switch
The switch used for the mow/transport slide is a normally closed switch. The
switch opens when the mow/ transport slide is in the transport position. The
switch is located under the floor plate
The Standard Control Module (SCM) monitors the position of the mow/ transport
switch (open or closed). Using inputs from the mow/transport switch and other
switches in the interlock system, the SCM control the energizing of the reel
drive solenoid.
1. Park vehicle on a level surface, stop engine, apply parking brake and remove
key from key switch.
2. Make sure the mow/transport switch is properly adjusted (see
Switch (page 6–7)).
3. Locate the switch and disconnect electrical connector from the switch.
4. Check the continuity of the switch by connecting a multimeter (ohms setting)
across the connector terminals.
5. When the switch plunger is extended (mow/transport slide in MOW position)
there should be continuity between the switch terminals.
6. When the switch plunger is depressed (mow/transport slide in TRANSPORT
position) there should be no continuity between the switch terminals.
7. Replace switch if testing determines that it is faulty.
8. Reconnect switch after testing.
Figure 128
(Figure 123).
Page 6–26
Mow/Transport
Reelmaster ® 3100-D/3105-D
20252SL Rev A