Rear Roller Brush - Optional - Toro Reelmaster 3100-D Service Manual

Rear Roller Brush – Optional
g343582
1. Brush bearing housing (non-drive)
2. Brush bearing housing (drive)
3. O-ring
4. Roller brush shaft
5. Flange nut (4 each)
6. Mounting bracket (2 each)
7. Excluder seal (2 each)
8. Flat washer (4 each)
Disassembling the Rear Roller Brush
DPA Cutting Units: Service and Repairs
9. Cap screw (4 each)
10. Spacer
11. Flat washer (for pulley alignment)
12. Driven pulley
13. Flange nut
14. Roller brush
15. Lock nut
16. J-bolt (2 each)
Note: Drive components for the rear roller brush are located on the opposite side
of the cutting unit from the cutting reel motor. Figure 55 shows components used
when the brush drive is on the left side of the cutting unit.
Note: The Installation Instructions for the rear roller brush kit has detailed
information regarding assembly and adjustment. Use those Instructions along
with this Service Manual when servicing the rear roller brush.
(Figure
1. Position machine on a clean and level surface, lower cutting units, stop
engine, engage parking brake and remove key from the key switch.
2. To remove the roller brush from brush shaft:
A. Remove the non-drive brush bearing housing (item 1) from cutting unit.
B. Slide excluder seal from roller brush shaft.
Figure 195
17.
18.
19.
20.
21.
22.
195)
Page 8–40
Grease fitting
Grease seal
Ball bearing
Grease fitting
Grease seal
Ball bearing
Reelmaster ® 3100-D/3105-D
20252SL Rev A