Adjustments; Adjusting The Brake - Toro Reelmaster 3100-D Service Manual

Adjustments

Adjusting the Brake

Reelmaster ® 3100-D/3105-D
20252SL Rev A
Before and after adjusting the brakes, always check the brakes in a
wide open area that is flat and free of other persons and obstructions.
1. Park machine on a level surface, lower cutting units, stop engine, and
remove key from the key switch.
g344069
1. Set screw
2. Adjustment knob
2. Adjust parking brake lever until a force of 133 to 178 N (30 to 40 lb) is
required to actuate lever. To adjust:
A. Loosen set screw on adjustment knob
B. Turn adjustment knob clockwise to increase force and counterclockwise
to decrease force.
C. Tighten set screw after adjustment.
g344070
1. Piston pump
3. Check brake adjustment as follows:
A. Rotate by−pass valve on the piston pump 90 degrees to allow front
wheels to turn freely
CAUTION
Figure 146
3. Brake lever
(Figure
Figure 147
2. By−pass valve
(Figure 147).
Page 7–3 Wheels, Brakes and Chassis: Adjustments
146).