Toro Reelmaster 3100-D Service Manual page 330

Removing the Reel Assembly (continued)
Installing the Reel Assembly
DPA Cutting Units: Service and Repairs
The spline insert on the left end of the cutting reel has left hand
threads and the spline insert on the right end of the cutting reel
has right hand threads.
D. Rest the handle of the pry bar against the front roller and loosen the
spline insert closest to the pry bar.
E. Position the pry bar in the same manner on the opposite end of the reel
and loosen the remaining spline insert.
F. Tip the cutting unit back onto its rollers.
5. Remove the bedbar assembly (refer to
(page 8–10)).
6. Remove the front and rear rollers (refer to
8–31) and Removing the Rear Roller (Figure 188) (page
7. Remove the cap screw and flat washer that secure rear grass shield to LH
side plate.
8. Remove flange head screw and washer that secures support rod to LH side
plate.
Note: The reel bearings and grease seals are press fit on the cutting reel
shaft and should remain on the reel when removing the LH side plate.
9. Remove three (3) shoulder bolts and flange nuts that secure the LH side
plate to the cutting unit frame. Remove the LH side plate from the reel shaft
and cutting unit frame.
10. Carefully pull the cutting reel assembly from the RH side plate.
11. Inspect and service cutting reel assembly as required (refer to
Service (page 8–26)).
1. Thoroughly clean side plates and other cutting unit components. Inspect side
plates for wear or damage and replace if needed.
2. Make sure that the grease seals and bearings are properly installed on
cutting reel (refer to
3. The cutting unit has O-rings in the reel bearing bore of each side plate.
Make sure that the O-rings are in good condition and properly installed in
the side plates.
IMPORTANT
Removing the Bedbar Assembly
Removing the Front Roller (page
Reel Assembly Service (page
Page 8–22
8–34)).
Reel Assembly
8–26)).
Reelmaster ® 3100-D/3105-D
20252SL Rev A