Toro Reelmaster 3100-D Service Manual page 208

Removing the Sidewinder
Installing the Sidewinder
Hydraulic System: Service and Repairs
Before disconnecting or performing any work on the hydraulic
system, all pressure in the system must be relieved. See
Hydraulic System Pressure (page
The hydraulic cylinder used in the Reelmaster sidewinder assembly is a
non−serviceable cylinder. Replace the cylinder if it becomes worn or damaged.
1. Remove the hydraulic cylinder from the frame using
2. If hydraulic fittings are to be removed from cylinder, mark fitting orientation to
allow correct assembly.
1. If hydraulic fittings were removed from cylinder, install fittings to cylinder
using marks made during the removal process to properly orientate fittings.
2. Install hydraulic cylinder to the frame using
3. Adjust scissors mount as follows:
A. Shift sidewinder fully to the left (fully retract cylinder).
B. Loosen four cap screws securing mount to lower frame.
C. The gap between the scissor frame and lower frame and the gap between
the scissor frame and the sidewinder carrier must be equal distances
within 1.5 mm (0.060 inch).
D. Tighten four cap screws and lock nuts.
WARNING
5–3).
Page 5–132
Relieving
Figure 100 as guide.
Figure 100 as guide.
Reelmaster ® 3100-D/3105-D
20252SL Rev A