Toro Reelmaster 3100-D Service Manual page 85

Installing an Adjustable Fitting (continued)
Reelmaster ® 3100-D/3105-D
20252SL Rev A
g221224
1. Locknut
3. Lightly lubricate the O-ring with clean hydraulic fluid. Ensure that the threads
of the fitting are clean with no lubricant applied
g212225
1. Step 1: clearance the lock nut
2. Step 2: seat the back-up washer
4. Turn back the locknut as far as possible. Ensure that the back-up washer is
not loose and it is pushed up as far as possible (Step 1 in
Before installing the fitting into the port, determine the material of
which the port is made. Installing a fitting into an aluminum port
requires a reduced installation torque.
5. Install the adjustable fitting into the port by hand until the washer contacts the
face of the port (Step 2 in
6. If the adjustable fitting needs to align with another component, rotate the fitting
counterclockwise until it is aligned to the desired position (Step 3 in
26). Do not rotate the adjustable fitting more than 1 turn counterclockwise.
Figure 25
2. Back-up washer
Figure 26
3. Step 3: align the fitting
4. Step 4: tighten the lock nut
IMPORTANT
Figure 26).
Page 5–9
3. O-ring
(Figure 25).
Figure 26).
Figure
Hydraulic System: General Information