Jacking Instructions - Toro Reelmaster 3100-D Service Manual

Jacking Instructions

Jacking the Front End
Jacking the Rear End
Reelmaster ® 3100-D/3105-D
20252SL Rev A
When changing attachments, tires, or performing other service, use
correct blocks, hoists, and jacks. Make sure machine is parked on a
solid level floor such as a concrete floor. Prior to raising machine,
remove any attachments that may interfere with the safe and proper
raising of the machine. Always chock or block wheels. Used jack
stands or solid wood blocks to support the raised machine. If the
machine is not properly supported by blocks or jack stands, the
machine may move or fall, which may result in personal injury.
Use the following positions when jacking up the machine:
g341980
1. Square tube
1. If the front wheel motor is to be removed, position jack securely under the
square tube of the lower frame as closely to the side plate as possible
(Figure 2).
2. If the front tire is to be removed, position the jack securely under the front
wheel motor.
3. Use jack stands or hardwood blocks under the square tube or wheel motors
to support the machine
g341981
1. Rear tire
CAUTION
Figure 2
2. Side plate
(Figure 2).
Figure 3
2. Rear casting
Page 1–7 Safety: Safety Instructions