Toro Reelmaster 3100-D Service Manual page 307

Traction Pedal (continued)
1. Bolt
2. Flat washer
3. Flat washer (3 each)
4. Rod end ball joint
5. Spacer
6. Grip ring
7. Bolt
8. Lever damper
9. Plain washer (2 each)
10. Flange head nut (8 each)
11. Forward pedal pad
12. Nut (2 each)
13. Lock nut
14. Traction pedal
15. Flange bushing (2 each)
16. Grease fitting
17. Slide
18. Lock nut
19. Flat washer
Reelmaster ® 3100-D/3105-D
20252SL Rev A
Figure 162 (continued)
20. Rocker arm
21. Bolt (2 each)
22. Flat washer
23. Bolt
24. Jam nut
25. Retaining ring (2 each)
26. Thrust washer
27. Traction pedal bracket
28. Rocker arm tube
29. Spring
30. Square nut
31. Nut (2 each)
32. Lock washer(2 each)
33. Lock nut
34. Flat washer
35. Neutral switch bracket
36. Proximity switch
37. Switch plate
38. Carriage bolt
1. Park machine on a level surface, lower cutting units, stop engine, engage
parking brake, and remove key from the key switch.
2. Remove and replace parts as necessary to repair traction pedal using
162 as a guide.
3. Adjust the traction drive for neutral; refer to Operator's Manual.
39.
40.
41.
42.
43.
44.
45.
46.
47.
48.
49.
50.
51.
52.
53.
54.
55.
56.
57.
Page 7–29 Wheels, Brakes and Chassis: Service and Repairs
Floor plate assembly
Carriage bolt (4 each)
Carriage bolt
Carriage bolt
Socket head screw
Nut
Plain washer
Reverse pedal pad
Flat washer
Carriage bolt
Bolt
Ball bearing
Retaining ring
Reverser pedal
Lock nut (3 each)
Spring
Washer
Traction control cable
Cable clamp
Figure