Toro Reelmaster 3100-D Service Manual page 230

Adjusting (continued)
Electrical System: Adjustments
g346738
1. Neutral switch
3. When the traction pedal is in the neutral position, the pin on the traction
pedal should be centered with the switch eye. With the traction pushed all
the way to the right, the clearance between the pin on the traction pedal and
the switch should be 0.5 to 1.5 mm (0.02 to 0.06 in)
4. To adjust the switch, loosen the nut securing the switch to the switch bracket
or the nuts securing the switch bracket to the floor plate and adjust the switch
position as needed.
5. After adjusting the switch, use the Standard Control Module (see
Control Module (SCM) (page
are functioning correctly. The switch should open when the traction pedal is
moved in either direction 6.3 to 25.4 mm (0.25 to 1.0 in) when measured at
the top of the traction pedal.
Figure 110
2. Traction pedal pin
6–45)) to verify that the switch and circuit wiring
Page 6–6
(Figure 110).
Standard
Reelmaster ® 3100-D/3105-D
20252SL Rev A