Toro Reelmaster 3100-D Service Manual page 345

Assembling the Roller
Reelmaster ® 3100-D/3105-D
20252SL Rev A
(Figure 189)
g195710
1. Roller tube
2. Inner seal
1. Install inner seals into roller tube making sure that seal lip (and garter spring)
faces end of tube. Use inner seal tool (refer to
and soft face hammer to fully seat seals against roller shoulder
190). Apply a small amount of grease around the lip of both inner seals
after installation.
During assembly process, frequently check that bearings rotate
freely and do not bind. If any binding is detected, consider
component removal and reinstallation.
g195711
1. Roller tube
2. Inner seal
2. Install new bearing and outer seals into one end of roller tube:
A. Position a new bearing into one end of roller tube. Use bearing/outer
seal tool (refer to
to fully seat bearing against roller shoulder
installation, make sure that it rotates freely with no binding.
B. Apply a small amount of grease around the lip of both outer seals.
Figure 190
3. Inner seal tool
IMPORTANT
Figure 191
3. Bearing
4. Bearing/outer seal tool
Special Tools (page 2–13)) with a soft face hammer
Page 8–37
Special Tools (page 2–13))
(Figure
(Figure 191). After bearing
DPA Cutting Units: Service and Repairs